Texas Star MOD Plus
Documentation Project
CBTricks.com
Texas Star Mod P CW Transmitter To AMP Conversion

1. Remove yellow 2200K cap from trace behind red power switch
2. Locate where the piggyback resistors connect to the red power switch.
3.

Add a jumper from there to the trace that the 2200K cap was connected
4. Remove red wire of oscillator board and attached 33-ohm resistor
5. Remove green wire of oscillator board and attached 33pf cap
6. Remove black wire of oscillator board from keying jack
7. Remove oscillator board
8. Solder the leg of the 15 or 18pf cap to input trace
9. Remove 180 or 190pf cap located next to 230pf cap at rear of board

Please Note the Warnings Below!

WARNING! This is a violation of FCC rules for Class D CB use in the U.S.A. The user is solely responsible for making sure that any modifications made to the unit must meet all Federal and State Regulations for the Country of use! Liability of damages to any equipment is the sole responsibility of the user! This information is not provided by, or affiliated in any way with the manufacturer of the products.

 

Copyright © 2001, 2002, 2003, 2004, 2005, 2006 CBTricks.com
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical, photocopying, or otherwise, without the prior written permission of the copyright holder (CBTricks.com).
All logos and Brand Names are the property of their respective owners.
http://www.cbtricks.com/

Disclaimer: Although the greatest care has been taken while compiling these documents,

we cannot guarantee that the instructions will work on every amp presented.