Texas Star DX1000V
Documentation Project
CBTricks.com
DX1000V CW Transmitter To AMP Conversion

1. Remove the top case screws (3) on each side.
2. Push in the (3) push button switches then carefully lift the rear of lid up approx 3/4", then slide the top towards the rear until the push button switches clear the front panel.
(Use caution not to damage the switches then lay cover upside down on the right hand side)
3. Remove yellow cap of oscillator board from the purple wire.
4. Solder this purple wire to rear pin of red power switch that has no wires attached to it.
5.

Remove red wire of oscillator board and attached 56-ohm 2-watt resistor (green, blue, black) at I5 (#7373 lamp) at front right of control board.
6. Remove green wire of oscillator board and attached 33pf cap.
7. Solder the leg of the 15pf cap to input trace.
8. Remove black wire of oscillator board from keying jack.
9. Remove oscillator board.
10.

Replace cover carefully making sure wire harness is in between fan rocker swirch and chassis. Then over hang the rear of the lid until push button clear front panel.
Slide the lid forward while guiding push buttons through the front panel opening. Replace screws.
NOTE: The internal rocker switch on driver board is set to on which is the fan position by default. This makes the 1/4" fan jack operate the optional external fans.
Switching this rocker switch to off enables 1/4" fan jack for optional remote control head.

Please Note the Warnings Below!

WARNING! This is a violation of FCC rules for Class D CB use in the U.S.A. The user is solely responsible for making sure that any modifications made to the unit must meet all Federal and State Regulations for the Country of use! Liability of damages to any equipment is the sole responsibility of the user! This information is not provided by, or affiliated in any way with the manufacturer of the products.
Copyright © 2001, 2002, 2003, 2004, 2005, 2006, 2007 CBTricks.com
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical, photocopying, or otherwise, without the prior written permission of the copyright holder (CBTricks.com).
All logos and Brand Names are the property of their respective owners.
http://www.cbtricks.com/

Disclaimer: Although the greatest care has been taken while compiling these documents,

we cannot guarantee that the instructions will work on every amp presented.